Analysis of the installation skills of stainless steel hose clamps

  In addition to the quality of fasteners used for stainless steel hose clamps, forming equipment, stringing equipment and molds are also key factors to ensure its quality. Especially in the case of a large supply of multiple varieties, how to ensure product consistency and prevent defects is one of the problems faced by fasteners. Let's take a look at the tips when installing stainless steel hose clamps.

  The matters needing attention when installing stainless steel hose clamps are as follows:

  (1) The distance L between the stainless steel hose clamp and the end pipe should be checked. The L command should be used in conjunction with the manual. When the gap between the two ends of the pipe is small, make sure that the stainless steel hose clamp is adhered to the inclined surface.

  (2) After determining the position of the stainless steel hose clamp, the gap size at both ends of the pipe should be determined by calculation according to the elongation rate of the pipe and the ambient temperature during construction. Ensure dimensional deviation during construction.

       (3) Assuming that there is a certain displacement distance, plus the height and width error of the weld between the stainless steel hose clamp and the end pipe, the elasticity of the verticality between the ring planes and the greater the axis of the end pipe, the smaller the expansion and contraction of the joint, The worse the use effect.

  (4) Impurities splashed when welding end pipes and stainless steel hose clamps will affect the sealing performance of the end pipes. The welding slag on the sealing surface should be removed before installation to ensure the sealing effect.